BM-4 Sterilization Equipment

Features

  • The walls of the sterilization chamber are coated with anodized aluminum.
  • Exterior finish black enamel baked metal , stainless steel and anodized aluminum.
  • Sterilizing agent : ethylene oxide 100%.
  • Team with a single gateway to the camera.
  • The ability of the camera from the computer BIOGAS M4 : 228 Lts .
  • The sterilization process has two default programmed cycles (37 ° C and 55 ° C. )
  • Our system is 100 % automatic (pre conditioning , humidification , gas injection , gas exposure , purge and vent )
  • BIOGAS Team M4 is controlled by the control board to adjust the process parameters (temperature , preheating, vacuum , humidity and exposure to gas).
  • The computer has a built- fault detection system at each stage of the process and makes the diagnosis by a microprocessor.
  • Includes double safety system to the door of the chamber ( anchor and handle ) during the sterilization period .
  • Tanque storage of water for humidification phase
  • Pantalla deployment variables during the sterilization process :
  • * - indicator of the process ( pre-conditioning , exposure , gas, ventilation) .
  • * - temperature indicator .
  • * - error code indicator .
  • Integrated printer for recording alphanumeric pressure , absolute humidity , temperature and error codes .
  • Relative humidity sensor with digital screen display and printer.
  • Negative pressure operation with a venturi system .
  • Catalytic system for the removal of Eto , Eto conversion into CO2 and water vapor with an efficiency of 99.9 %.
  • Cabin breather , supplemental.
  • Monitor ethylene oxide (air / staff ) .
  • Built-in audible alarm and visual message.
  • Relative humidity sensor inside the camera .
  • Aeration time programmable default aeration takes 3 hours after exposure to ETO.

Accessories

  • Incubator for biological controls.
  • One (1 ) 5HP air compressor with tank 250lts and refrigeration air dryer.
  • Two (2 ) diffusion for passive monitors include ethylene oxide analysis.
  • Vent ducts shall be copper.
  • electric transfer trolley , stainless steel to move , raise and lower materials and supplies in the sterilization plant ( capacity : 68 Kg )
  • Bountiful , made ​​of materials that do not cause oxidation.

Consumables

  • Ten ( 10) rolls of printer paper builtTwo . .
  • printer cartridge .

Installation

  • Electric current 220 VAC or 230 VAC / 60 Hz
  • Voltage Stabilizer or UPS .

Training

  • -For personnel at least 06 hours with certification.

Maintenance

  • Preventive and corrective maintenance by qualified personnel. Minimum 2-year warranty .

Standards

  • ISO 9001-2008